RISK MANAGEMENT AND
PREPARATION OF SOP'S FOR A&E
() (A+ GUARANTEED)
Question :Which type of risk endangers lives or
resources without contributing to mission accomplishment?
Correct answer:An unnecessary risk
Question :Which Army publication provides specific
information to implement RM policies and procedures?
Correct answer:DA PAM 385-30
Question :In which phase of the RM process is the
hazard control plan developed and put into action?
Correct answer:Management phase
Question :In the assessment phase, RM practitioners
identify hazards and
Correct answer:Assess hazards
Question :what is a condition with the potential to cause
a harmful event such as injury, illness, or loss of equipment of property?
Correct answer:Hazard
Question :In this hazard scenario, what is the outcome?
Stored blasting materials + Exposure to heat = Detonation or explosion
Correct answer:Detonation or explosion
Question :Why does the RM practitioner estimate the
probability and level of severity for each hazard in step 2 of the RM process?
Correct answer:To assign a level of risk to each hazard.
Question :Which term describes the extent of expected
harm from an event, in terms of amount of injury, property damage, or other mission-impairing effect?
Correct answer:Severity
Question :Per ATP 5-19, Table 1-1, what is the
probability for a harmful occurrence expected to happen infrequently (remotely possible, could occur at some time)?
Correct answer:Unlikely (NOT THE ANSWER)
Question :Per ATP 5-19, Table 1-1, what is the severity
of a hazard if its expected consequences include complete mission failure or unacceptable collateral damage?
Correct answer:Severity is estimated as
>CATASTROPHIC< when consequences of an event, if it occurs, are expected to include death, unacceptable loss or damage, mission failure, or the loss of unit readiness.
Question :Per ATP 5-19, Table 1-1, what is the risk level
for a hazard with likely probability and negligible severity
Correct answer:Low
Question :Which information is NOT part of a hazard
control action plan?
Correct answer:Negotiations
Question :When supervising action plans, which action
is NOT something supervisors do to ensure awareness, training, and compliance?
Correct answer:Delegate supervisor duties
Question :Which is NOT a goal of evaluation feedback?
Correct answer:Ensure hazard controls are not revised
once they are implemented
Question :The Army requires SOPs for complex tasks,
those involving hazardous materials, and
Correct answer:All operations involving A&E
Question :What is the purpose of an SOP?
Correct answer:To provide clear, concise guidance to
operation personnel and aid in the training of operators.
Question :Several publications may be referenced when
developing SOPs including DA PAM 700-107, ATP 3- 90.90, and
Correct answer:The SOP portal
Question :What is the last step in the sop development
process?
Correct answer:Review SOP
Question :When developing an SOP, the first step is to
Correct answer:Determine the SOP objective.
Question :When writing an SOP, which step requires
you to explain each operating procedure in detail including how to carry it out?
Correct answer:Write detailed operating instructions
Question :Select the correct sequence of steps used for
SOP review and concurrence.