OSHA 10 Hour Construction Test Answer Key FALL HAZARDS Click Safety
- Both A and B are correct (correct answer)
Get OSHA 10 Exam Passed - https://rebrand.ly/clisafo10consqr - answer1. OSHA
requires fall protection at different heights for construction and general industry however, regardless of the fall distance, which of the following is most
- Fall protection must be provided when working over dangerous equipment
- Fall protection must be provided when working over dangerous machinery
- Both A and B are correct
- None of the above
Get OSHA 10 Exam Passed - https://rebrand.ly/clisafo10consqr
- It is determined to have strength and structural integrity to support intended loads
(correct answer) Get OSHA 10 Exam Passed - https://rebrand.ly/clisafo10consqr - answer2. Employees
must not work on scaffold surfaces until:
- It is determined to have strength and structural integrity to support intended loads
- OSHA has visited the site and inspected the scaffold
- The surface is completely dry
- All of the above
Get OSHA 10 Exam Passed - https://rebrand.ly/clisafo10consqr
- All the above (correct answer)
- Roof edges and floor openings
- Steel erection
- Improper scaffold construction
- Unsafe use of portable ladders
- All the above 1 / 2
Get OSHA 10 Exam Passed - https://rebrand.ly/clisafo10consqr - answer3. From your choices below, what would you consider to be a "major" fall hazard in construction?
Get OSHA 10 Exam Passed - https://rebrand.ly/clisafo10consqr
- Never (correct answer)
Get OSHA 10 Exam Passed - https://rebrand.ly/clisafo10consqr - answer4. Climbing on
the cross braces of scaffolds is allowed:
- During the assembly of the scaffold
- When conditions are dry and the climbing can be done safely
- Never
- When authorized by the supervisor
Get OSHA 10 Exam Passed - https://rebrand.ly/clisafo10consqr
- Removed immediately from service (correct answer)
Get OSHA 10 Exam Passed - https://rebrand.ly/clisafo10consqr - answer5. If there are defects found during the inspection of personal fall protection equipment, or if the
equipment has been used in an arrest, it must be:
- Fixed on the spot and tested by twisting the fabric or rope and looking for stress
- Turned in at the end of the shift
- Removed immediately from service
- None of the above
Get OSHA 10 Exam Passed - https://rebrand.ly/clisafo10consqr
- Roofs (correct answer)
Get OSHA 10 Exam Passed - https://rebrand.ly/clisafo10consqr - answer6. More than
33% of fatalities in construction are from a combination of falls from:
- Slips and slides
- Tripping over electrical wires and electrical installations
- Roofs
- None of the above
Get OSHA 10 Exam Passed - https://rebrand.ly/clisafo10consqr
- All the above (correct answer)
Get OSHA 10 Exam Passed - https://rebrand.ly/clisafo10consqr - answer7. Examples of
fall hazards that have resulted in deaths on the jobsite include:
- Falls to the ground or lower levels
- Falls through existing floor or roof openings
- / 2