NACE CIP 1 CBT EXAM PRACTICE
Questions with Complete Solutions Dew point is the temperature at which - Correct Answers ✅condensation occurs.You are the NACE Inspector on a tank lining project where a 50% solids epoxy tank lining is being applied. After application of the 19 coat you notice small blisters in some areas of the applied lining. Your FIRST preferred course of
action is to: - Correct Answers ✅Document the problem
and advise the Contractor and Owner's representative.If a contractor is using a poorly maintained compressor to supply air for abrasive blast cleaning and conventional airspray, the coating inspector should perform a - Correct Answers ✅blotter test for the presence of oil and water.Upon arrival of coating materials, the inspector should - Correct Answers ✅observe and document the amount of material and batch numbers.Relative humidity is - Correct Answers ✅a measure of the amount of moisture in the air compared to saturation level.Galvanic corrosion occurs on which of the following substrates? - Correct Answers ✅Metal 1 / 3
NACE CIP 1 CBT EXAM PRACTICE
Questions with Complete Solutions When applying Thermal Spray Coatings the specification is
most likely to reference: - Correct Answers ✅SSPC-CS
23.00/AWS C2.23/NACE No. 12 What is the minimum recommended distance away from an edge that an inspector should take a measurement with a dial type magnetic pull off Dry Film Thickness(DFT) gauge? - Correct Answers ✅2.5 cm (1 inch) Polymerization is the process of? - Correct Answers ✅Monomers joining together.An exposed area of the substrate or previous coat of a conductive material, often caused by poor application
technique is called: - Correct Answers ✅Holiday
Checking is: - Correct Answers ✅a fine crack in the surface
of a coating that rarely reaches the substrate.
Inspection documentation is important because: - Correct
Answers ✅Owners use the documentation for a variety of purposes.
An Inspectors personal log book should contain: - Correct
Answers ✅No comments regarding the application team. 2 / 3
NACE CIP 1 CBT EXAM PRACTICE
Questions with Complete Solutions You have just received your NACE CIP Level 1 certification when you are asked to supervise a team of uncertified field pipeline inspectors. Your FIRST preferred course of action is
to: - Correct Answers ✅Review the NACE Attestation prior
to making a decision.Good record can provide maintenance departments with
detailed information about ALL of the following EXCEPT: -
Correct Answers ✅How the item was coated.
Non Conformance Reports are completed by the Inspector: -
Correct Answers ✅When the Inspector and Contractor deem it to be significant non conforming item.The initial steel condition is important to the NACE Inspector
because: - Correct Answers ✅The Inspector may have to
reject the steel.The form of corrosion that has the largest potential for
unexpected catastrophic failure is: - Correct Answers
✅Galvanic Corrosion What is used to determine compressed air cleanliness? - Correct Answers ✅Profilometer
Osmotic blistering is most likely to occur as a result of: -
Correct Answers ✅Airless spray application.
- / 3