MACWIC Sample EXAM QUESTIONS AND

MACWIC Sample EXAM QUESTIONS AND ANSWERS 100% score (Newest 2025)

• Which is NOT a method of inputting programs into the

controller?

• RS232
• Floppy disks and USB Drives
• Tapes and tape readers
• An operator reading instructions at the controller -

Correct Answers ✅d. An operator reading instructions at the controller

• If the oil level falls below the MINIMUM line an Alarm

Message will be displayed.

• True
• False - Correct Answers ✅a. True
• G41 is
• Absolute Programming
• Incremental Programming
• Cutter Compensation Left
• Cutter Compensation Right - Correct Answers ✅c.

Cutter Compensation Left

• The major difference between the horizontal and vertical

machining center is:

• Spindle orientation. 1 / 4

MACWIC Sample EXAM QUESTIONS AND ANSWERS 100% score (Newest 2025)

• Spindle speed.
• Servomotor size.
• Servomotor power. - Correct Answers ✅a. Spindle

orientation.

• The Jog Mode on a machine lets the operator move the

machine in small, determined increments.

Select one:

• True
• False - Correct Answers ✅a. True
• The block delete mode allows the operator to
• Run a slightly different version of the program by leaving

out certain lines

• Skip the long parts of the program
• Program in special part features
• Edit the cutting variables of the program - Correct

Answers ✅a. Run a slightly different version of the program by leaving out certain lines

• Overrides are used to
• Maximize a threading operation
• Adjust machine variables 2 / 4

MACWIC Sample EXAM QUESTIONS AND ANSWERS 100% score (Newest 2025)

• Extend tool life - Correct Answers ✅b. Adjust machine

variables

• You should verify the active program is the program that is

intended to run.

Select one:

• False
• True - Correct Answers ✅b. True
• G91 is
• Cutter Compensation Right
• Cutter Compensation Left
• Incremental Programming
• Absolute Programming - Correct Answers ✅c.

Incremental Programming

• Which axis is usually associated with the spindle of the

machine?

• A axis
• Y axis
• Z axis
• X axis - Correct Answers ✅c. Z axis
• Which statement about cutting tool material is true? 3 / 4

MACWIC Sample EXAM QUESTIONS AND ANSWERS 100% score (Newest 2025)

• Solid end mills are often made of high-speed steel.
• Only end mills are capable of using indexable carbide

inserts.

• The face mill is generally considered a single point tool. -

Correct Answers ✅a. Solid end mills are often made of high-speed steel.

• Common file extensions for a CNC program include
• .TXT
• .CNC
• .NC and .TXT
• .NC - Correct Answers ✅c. .NC and .TXT
• .NC
• What is the correct code for canceling cutter

compensation?

• G40
• G80
• M28
• G43 - Correct Answers ✅a. G40
• A milling cutter capable of producing a flat cut and

designed with cutting teeth winding up the side of the tool is called?

• / 4