MA 1c Hoisting License Exam 2025 With 200

pg. 1 MA 1c Hoisting License Exam 2025 With 200 Prep Questions And Correct Verified Answers/ Mass 1c Hoisting Test 2025/ Massachusetts 1c Hoisting Exam 2025 (Brand New!)

What is the most important single factor to the safe operation of forklifts?

• the weather
• the operator
• the forklift's design
• the operator

What equipment falls under a 1C license?Hydraulic telescoping booms without wire ropes and forklifts When the forklift's center of gravity goes beyond the stability area?

• the hydraulic system will not work
• the governor will slow the engine
• the forklift will tip over
• the hand brake should be set
• the forklift will tip over

Many accidents happen because the operator does which of the following?

• uses a forklift with a known defect
• travels on unsafe roads
• carries unsafe loads
• uses unsafe operating techniques
• all of the above
• all of the above

because the forklifts are designed with the forks in the front, it is not possible for it to tip backwards.

• true
• false
• false 1 / 4

pg. 2 the type of forklift which is designed primarily to lift a load straight up with a limited amount go tilt movement forward is the?

• arm and mast forklift
• boom forklift
• mast forklift
• extended reach forlklift
• mast forklift

Which of a forklift's four wheel steering capabilities should be used at high speeds or on Highways?

• four wheel steering, front and back wheels pointing in opposite directions
• four wheel steering, front and back wheels pointed in the same direction (crab

steering)

• two wheel steering, front wheels fixed straight ahead, rear wheels used for

steering

• any of the above, since they are all equally safe at high speeds
• two wheel steering, front wheels fixed straight ahead, rear wheels used for

steering Using a short turning radius when traveling at high speeds can cause overturning due to?

• a shift in the center of gravity
• the forces of momentum
• the teeter totter principle
• all of the above
• the forces of momentum

when is it permissible to carry riders while you are operating a forklift?

• when there is room for them in the operators compartment
• if they never ride on the rear counterweight
• never
• when they do not obstruct your vision
• never

if a forklift tips forward?

• steering control is lost
• the hydraulic frame level system will correct the problem 2 / 4

pg. 3

• the outriggers should be placed quickly
• none of the above
• steering control is lost

when traveling up or down a ramp, you can place more traction on the front price wheels of an unloaded forklift if the forks are?

• kept pointed uphill
• kept pointed downhill
• pointed either way since it makes no difference which way the forks are pointed
• kept pointed downhill

rear wheel steering used by many forklifts?

• causes both ends of the forklift to swing around when turned
• can cause the load to fall off the forks if the turn is made too fast
• causes them to act different than cars which have front wheel steering
• all of the above
• all of the above

when is it safe to operate the forklift from a place other than the operators seat?

• when you can reach the controls while standing on the ground
• when the engine is not running
• when the emergency brake is set
• never
• never

workers and bystanders within the danger area of the forklift should be considered the responsibility of?

• the supervisor
• the fellow worker on the scaffold giving the landing instructions
• the contractor
• the operator
• the operator

which of the following are essential for safe operation?

• smooth starts
• smooth stops 3 / 4

pg. 4

• smooth turns
• all of the above
• all of the above

the operator feathers the controls when he wants to?

• cycle the hydraulic system
• move the load slowly
• start the forklift in cold weather
• test the brakes
• move the load slowly

If you find a fault or suspect an unsafe condition while inspecting or operating a forklift you should?

• take the forklift out of service at the end of the shift
• tell one of your fellow workers
• tell your supervisor
• not worry about it, since it is not your responsibility
• tell your supervisor

if bystanders or fellow workers are in danger from a raised load, you should?

• continue working
• sound your horn or ask them to leave
• not worry about them if they are wearing hard hats
• sound your horn or ask them to leave

which of the following affect forklift safety?

• leverage
• center of gravity
• momentum
• all of the above
• all of the above

the pivot point of a forklift is?

• the load center
• the center of gravity
• the front axle
• the wheel base
• / 4