- | Page
J-STD-001 EXAM QUESTIONS AND
CORRECT ANSWER S NEW
UPDATE
Question: Who is responsible for identifying the assembly
class?
CORRECT ANSW ER: User
Question: What is a defect?
CORRECT ANSWER : A condition that may affect the
form, fit, or function of the item in the end use environment
Question: Hardware found to not conform to the
requirements of the standard shall be classified as defects
and dispositioned for:
CORRECT ANSWER : [D1D2D3]
Question: There shall be no broken strands for wires used
at a potential of 6kV or greater:
CORRECT ANSWER : [D1D2D3]
- | Page
Question: A documented process control system shall be
implemented for:
CORRECT ANSWER : [N1N2D3]
Question: The contract shall take precedence over this
standard for:
CORRECT ANSWER : [D1D2D3]
Question: What is wire overlap?
CORRECT ANSWER : When a wire is wrapped more
than 360 and crosses over itself
Question: What is wire over wrap?
CORRECT ANSWER : When a wire is wrapped more
than 360 and remains in contact with the terminal
Question: Manufacturers shall perform 100% inspection
unless sampling inspection is defined for:
CORRECT ANSWER : [N1D2D3]
- | Page
Question: Inspection of soldering and cleanliness shall be
performed prior to conformal coating, staking, or
encapsulation for:
CORRECT ANSWER : [N1D2D3]
Question: Illumination at the surface of work stations
should be at least what?
CORRECT ANSWER : 1000 lux
Question: What is the tolerance for magnification aids?
CORRECT ANSWER : +- 15%
Question: Eating, drinking, smoking, e-cigs use shall be
prohibited at the work station for:
CORRECT ANSWER : [D1D2D3]
Question: Manufacturer shall verify ESD is adequate
when humidity falls below 30% for:
CORRECT ANSWER: [N1D2D3]
- | Page
Question: Manufacturer shall establish an ESD control
program for:
CORRECT ANSWER : [D1D2D3]
Question: What is J-STD-002?
CORRECT ANSWER : Solder-ability tests for
Component leads, terminations, lugs, wires, and terminals
Question: What is J-STD-003?
CORRECT ANSWER : Solder ability tests for printed
boards
Question: What is J-STD-004?
CORRECT ANSWER : Requirements for Soldering
Fluxes
Question: What is J-STD-005?
CORRECT ANSWER : Requirements for Soldering
Paste