IICL Container Inspectors Exam

IICL Container Inspector's Exam Questions And Answers

Question 1: Which of the following defects requires repair?

• A loose door gasket
• A bent J-bar that does not affect door operation
• A dent 13mm (1/2 in) deep on the door sill
• Four dents, each 11mm (7/16 in) deep, on contiguous

outboard corrugations of a roof panel

CORRECT ANSWER : A. A loose door gasket

Question 2: Of the following conditions in a dry-van

container, which one would require cleaning?

• Raised mud foot prints in excess of what might normally

remain after a sweep out

• Dry dust covering dried floor stains as might normally be

found after a sweep out

• Coffee beans remaining inside the container as might occur

after a sweep out

• Polyurethane beads as might be expected to lodge in

grooves between floorboards after a sweep out

CORRECT ANSWER : C. Coffee beans remaining inside the

container as might occur after a sweep out

Question 3: An Equipment Interchange Receipt (EIR), based

on an inspection with no damage found, can be evidence of a

container's compliance with:

• Australian Timber Component Treatment Regulations
• Convention for Safe Containers (CSC) regulations through

the ACEP Program

• Transport under custom's seal (TIR) regulations
• International Standards Organization (ISO) CEDEX codes

regulations

CORRECT ANSWER : B. Convention for Safe Containers

(CSC) regulations through the ACEP Program

Question 4: The top of a replacement plastic ventilator should

be centered what distance from the top side rail?

• 50-55mm (2-2 3/16 in)
• 70-75mm (2 5/8 - 3 in)
• 100mm (4in)
• 150mm (6 in)

CORRECT ANSWER : A. 50-55mm (2-2 3/16 in)

Question 5: When must a reference line extend the full length

of a bottom side rail?

• When there are two or more areas of damage on the

bottom side rail

• When there is a sharp bend in the bottom side rail
• When there is a bowing over the entire bottom side rail
• When there is additional damage to the bottom side rail so

that the reference line cannot be positioned over the ends of the damage

CORRECT ANSWER : C. When there is a bowing over the

entire bottom side rail

Question 6: Which of the following is NOT a transverse

structural member of the container?

• Front sill
• Tunnel rail
• Rear header
• Crossmember

CORRECT ANSWER : B. Tunnel rail

Question 7: A steel corner fitting is being replaced. To ensure

better weld penetration, IICL recommends that the edges of parts adjacent to the corner fitting be ground to a minimum bevel of?

• 30 degrees
• 45 degrees
• 55 degrees
• 60 degrees