IICL CONTAINER INSPECTORS

• | Page

IICL CONTAINER INSPECTOR'S

EXAM QUESTIONS WITH

SOLUTIONS GRADED A

Question :Which of the following defects requires repair?

• A loose door gasket
• A bent J-bar that does not affect door operation
• A dent 13mm (1/2 in) deep on the door sill
• Four dents, each 11mm (7/16 in) deep, on contiguous

outboard corrugations of a roof panel

Correct answer:A. A loose door gasket

Question :Of the following conditions in a dry-van

container, which one would require cleaning?

• Raised mud foot prints in excess of what might

normally remain after a sweep out

• Dry dust covering dried floor stains as might normally

be found after a sweep out

• Coffee beans remaining inside the container as might

occur after a sweep out

• | Page

• Polyurethane beads as might be expected to lodge in

grooves between floorboards after a sweep out

Correct answer:C. Coffee beans remaining inside the

container as might occur after a sweep out

Question :An Equipment Interchange Receipt (EIR),

based on an inspection with no damage found, can be

evidence of a container's compliance with: A. Australian

Timber Component Treatment Regulations B. Convention for Safe Containers (CSC) regulations through the ACEP Program

• Transport under custom's seal (TIR) regulations D.

International Standards Organization (ISO) CEDEX codes regulations

Correct answer:B. Convention for Safe Containers (CSC)

regulations through the ACEP Program

Question :The top of a replacement plastic ventilator

should be centered what distance from the top side rail?

• 50-55mm (2-2 3/16 in) B. 70-75mm (2 5/8 - 3 in)
• 100mm (4in) D. 150mm (6 in)

• | Page

Correct answer:A. 50-55mm (2-2 3/16 in)

Question :When must a reference line extend the full

length of a bottom side rail? A. When there are two or more areas of damage on the bottom side rail B. When there is a sharp bend in the bottom side rail

• When there is a bowing over the entire bottom side rail
• When there is additional damage to the bottom side

rail so that the reference line cannot be positioned over the ends of the damage

Correct answer:C. When there is a bowing over the entire

bottom side rail

Question :Which of the following is NOT a transverse

structural member of the container?

• Front sill B. Tunnel rail
• Rear header
• Crossmember

Correct answer:B. Tunnel rail

• | Page

Question :A steel corner fitting is being replaced. To

ensure better weld penetration, IICL recommends that the edges of parts adjacent to the corner fitting be ground to a minimum bevel of? A. 30 degrees B. 45 degrees

• 55 degrees D. 60 degrees

Correct answer:B. 45 degrees

Question :Which of the following components is

sometimes placed longitudinally in the container to support plywood flooring? A. Transverse bow B. Gusset

• Hat section center spacer
• Threshold plate

Correct answer:C. Hat section center spacer

Question :Assuming owner and environmental regulations

permit, which of the following procedures is NOT recommended for repairing tarpaulins or open top containers? A. Cleaning the area to be covered with acetone or mineral spirit B. Using a heat gun to fuse a patch to the tarpaulin C. Sewing on a patch of the same