IAAI CFI Study EXAM QUESTIONS AND ANSWERS 100% SOLVED (Newest 2025) A liquid with a flash point ABOVE 100F - Correct Answers ✅Combustible Liquid If the current flowing out from an electrical panel is 12.5 amps, and it then flows through an electrical load of 1500 watts, what is the amperage of the remaining current flow of the return circuit? - Correct Answers ✅12.5 If a hair dryer draws 8.3amps (in a home with 120-volt service), what is the wattage?*Power (P) = current (I) x voltage (V) Watts = amps x volts - Correct Answers ✅1000 The year of the first edition of NFPA 1033 - Correct Answers
✅1987
The recommended distance for securing the perimeter of a blast scene *That is, the distance from the furthest debris - Correct Answers ✅1.5 times What temperature in the upper gas layer causes the onset of Flashover? - Correct Answers ✅1100°F 1 / 4
IAAI CFI Study EXAM QUESTIONS AND ANSWERS 100% SOLVED (Newest 2025) The temperature at which copper melts - Correct Answers
✅1960°F
The measurement of the radiant heat flux (from gas layer to the floor) that indicates the onset of flashover - Correct Answers ✅2 W/cm2 The voltage between the two hot wires at the service entrance cables in most single-family residences in the United States (single-phase service with three wires) - Correct Answers ✅240 volts The revision cycle for NFPA 921 (timespan) - Correct Answers ✅3 years The flash point of power steering fluid - Correct Answers
✅350°F
In high-pressure fuel-injected vehicles, this is the typical range of pressure that is used to pump fuel from a fuel tank - Correct Answers ✅35-70 p.s.i.The lower explosive and upper explosive limit of natural gas (methane)? - Correct Answers ✅5 and 17 2 / 4
IAAI CFI Study EXAM QUESTIONS AND ANSWERS 100% SOLVED (Newest 2025) The ignition temperature of power steering fluid - Correct Answers ✅680°F Any substance that can undergo combustion - Correct Answers ✅Fuel Two factors or situations leading to a fire that may show the nature of the incident responsibility. - Correct Answers ✅Act or Omission This concept should not be included in a summary report of findings. - Correct Answers ✅Additional Investigative Recommendations A law that may govern the fire investigation of a boat - Correct Answers ✅Admiralty Law A type of device in a vehicle, which can cause an electrical overload to factory installed wiring - Correct Answers ✅After-market Equipment Evidence of smoke or soot in the lungs, bronchi, and trachea is one of the most significant factors in confirming that, at the time of the fire, the victim was WHAT? - Correct Answers ✅Alive and Breathing 3 / 4
IAAI CFI Study EXAM QUESTIONS AND ANSWERS 100% SOLVED (Newest 2025) Those who have the responsibility for monitoring safety conditions at the fire or explosion scene - Correct Answers ✅All Team Members The melting temperature of aluminum - Correct Answers
✅1220°F
Which one of these is NOT considered a competent ignition source?Metal-to-metal sparks, Aluminum-to-pavement sparks, Metal-to-pavement sparks, Motor bearing sparks - Correct Answers ✅Aluminum-to- pavement sparks A meaningful analysis of a fire requires an understanding of the fire growth, the total heat released, and WHAT? - Correct Answers ✅Heat Release Rate What does he term AFCI stand for? And, the "A" specifically represents what? - Correct Answers ✅Arc-fault circuit interrupter The organization that develops standard methods for testing materials - Correct Answers ✅ASTM
- / 4