CWEA Electrical and Instrument Grade 2 Exam New

Study Guides Aug 17, 2025
Loading...

Loading document viewer...

Page 0 of 0

Document Text

CWEA Electrical and Instrument Grade 2 Exam New 2024-2025 Version Best Studying Material with All Questions and Answers

Temporary traffic control lanes created as part of a Temporary Traffic Control Zone setup on a street with a 35 MPH maximum speed limit shall be a minimum width of: ----------- Correct Answer ----------- 10 feet

For a night time Short Term Stationary Temporary Traffic Control Zone setup on low speed/low volume street, the minimum height of the traffic cones used shall be: ----------- Correct Answer -- --------- 28 inches

After completing a Temporary Traffic Control setup for your work zone it is a good practice to: - ---------- Correct Answer ----------- Observe how effective your TTC setup is working to control traffic and make the necessary changes to it if necessary

When a citizen wants information regarding a maintenance operation you should give them as much factual information as you can, and offer to help them further, true or false? ----------- Correct Answer ----------- True

You are the lead on a high priority critical pump repair. Your co-worker decides it's a good time to take a break. You know that the job will take ten minutes if you have their help. What should you do? ---------- Correct Answer ----------- A. Do the job yourself.

  • Get someone else to help you.
  • Calmly explain the importance of the job and that once it is done a break can be taken.
  • Take a break and then do the job.

Rationale: This approach promotes teamwork and ensures the critical task is completed efficiently. It also shows leadership by calmly addressing the situation and emphasizing the urgency of the repair.

A 480V, 3 phase motor, Delta connected, has one leg shorted, what will the resistance be compared to the other legs ---------- Correct Answer ----------- A. Greater *B. Lower

  • Same
  • Greater or lower

What is the "haunch zone" of an excavation? ---------- Correct Answer ----------- Either side of the arched section in the bottom half of the pipe

What document would you require to be referenced when developing an S.O.P for hazardous substace spill clean up? ---------- Correct Answer ----------- MSDS

You arrive at an SSO and relieve the stoppage 27 minutes after a call was placed to report it. You 1 / 4

find that the spill was running at 6 gallons per minute, how much sewage went uncaptured? ------ ---- Correct Answer ----------- 162 gallons

What is the minimum length of a taper in a temporary traffic control setup? ---------- Correct Answer ----------- 50ft.

What are some examples of level control devices (devices that turn a pump at a pump station on and off)? ---------- Correct Answer ----------- Bubbler Level Gauge, Mercury/Mechanical Float Switches, Ultra Sonic Sensor

A 12V battery rated to provide 1amp for 20 hours across a 2000w load. How long will the battery continue to produce an output? ---------- Correct Answer ----------- A. 1 hour

  • 10 hour
  • C.*** 100 hour

  • 1000 hour

A tank is 30' high, 26' wide, filled 14'. What is the volume? I believe you should assume this tank is a cylinder. Pay attention if the question ask for the tanks volume or the volume of the fluid inside the tank. ---------- Correct Answer ----------- Do Calculations

A 36" pipe has an elevation gain of 300', the process reaches an elevation of 200'. What is the PSI? ---------- Correct Answer ----------- Do Calculation

A pipe has a 10" opening , and produces 2500 GPM. How many cubic feet/sec? ---------- Correct Answer ----------- Do Calculations

What is the characteristic of resistance in copper wire? ---------- Correct Answer ----------- It is inverse to its cross-sectional area.

What is the maximum time between taking a class in NFPA70E? ---------- Correct Answer ------- ---- 1 year

OSHA or maybe it was some other agency???? Says the most common cause of electrical accidents among those that work with electricity is? ---------- Correct Answer ----------- A.***Contact with overhead lines, misuse of electrical cords, not using equipment for intended purpose, not following manufactured guidelines.

  • Not wearing appropriate PPE
  • Misuse of large equipment, not setting up boundaries

D. XXX

You get called out to a lift station, the HMI screen is blank. What do you do? ---------- Correct Answer ----------- A. Call information systems or IT to fix.

  • Turn it off/on
  • *C. Notify operations to monitor the system while you troubleshoot and fix.

D. XXX

  • / 4

What appropriate steps to minimize affecting the process when tasked with fixing or replacing an Influent Pump? Think these steps out, what makes the most sense. What will not affect the process. What will reduce issues when doing the work. ---------- Correct Answer ----------- A.Trouble shoot, order material, perform work, create work order, notify operations.

  • Notify ops, order material, perform work.
  • Perform work, notify ops, create work order.
  • *Troubleshoot, gather material, coordinate with operations, schedule date, create work order,
  • perform job, update work order.

When should information be documented to be revisited or reviewed at a later date. ---------- Correct Answer ----------- A. How many people worked that day.

  • ***Unauthorized person onsite, jobsite conditions.
  • Soil conditions

D. XXX

You approach a piece of equipment that is off or not working, the circuit breaker is in the tripped position, what is the best way to troubleshoot? ---------- Correct Answer ----------- Inspect the load side for obvious signs of overloading, cautiously reset the breaker, amp check the load.

What is it called when someone teaches safety? ---------- Correct Answer ----------- Safety training

What is PPE Category 1? ---------- Correct Answer ----------- Arc-Rated clothing, Minimum Arc Rating of Arc 4 cal/cm2 arc-rated long sleeve shirt and pants or overall

Parshall Flume Measurement point? 1.2 FT Water Height 20.8xH at measurement point ----------

Correct Answer ----------- Possible answer:72,607 MGD

Absoulte Pressure Gauge? What is True? ---------- Correct Answer ----------- Possible answer: Read more accurate or 14.7 PSI higher

Flow meter that uses electrodes is? ---------- Correct Answer ----------- Magnetic Flow Meters

What is the resister color code : Orange, White,Silver,Gold Band ---------- Correct Answer ------- ---- .39 Ohms

Pitot tube measures? ---------- Correct Answer ----------- Measures Fluid or Gas Velocity

Chlorine Analyzer reads lower ever time but grab sample shows level are good. What do troubleshoot first? ---------- Correct Answer ----------- Buffer

How to complete a work order when asked to maintain a pump? ---------- Correct Answer -------- --- Notify Operation, purchase parts, maintain, test, notify complete

What shunt resister rating to make 1-5V change on 4-20ma signal? ---------- Correct Answer ----- 3 / 4

------ 250 ohms

HMI Screen down at the pump station, what to do? ---------- Correct Answer ----------- Ask operator to monitor while you troubleshoot and try to fix

Where does the fluid enter in a Rotameter? ---------- Correct Answer ----------- Bottom

RPM on 4 pole 60 Hz motor ---------- Correct Answer ----------- 1800 RPM

For every 10 Celsius change in operating temp. What happen to motor wire insulation? ---------- Correct Answer ----------- Degrades 50%

What is it called when teaching someone Electrical Task Training? ---------- Correct Answer ----- ------ Safety Task Training

Personnel injured when working around machines/equipment depending what they do. Based on this: What two classification? ---------- Correct Answer ----------- Authorized-Affected

Resistors wired in parallel on battery 5 ohms, 10 ohms, and 20 ohms.what must be the voltage to force 2.4 amp ? ---------- Correct Answer ----------- 6.84 V

Best way to test someone after training them? ---------- Correct Answer ----------- Have them teach others or have them perform the task under supervision

What is amperage 1000 Watts pulled through 12.5 ohms? ---------- Correct Answer ----------- 8.9 amps

What is one way to prolong life of vertical shaft well motor? ---------- Correct Answer ----------- make sure plenty of grease, lube bearings, make sure fail seal hooked up

Grounding analog signal both end of wire or one end only? ---------- Correct Answer ----------- Ground only one end analog of wire

.15KvA transformer 480-120. How much amps can you pull on 120 side? ---------- Correct Answer ----------- 1.25 amps 150/120=1.25 amp

What are transformer measured in? ---------- Correct Answer ----------- KVA

What should flow meter read in this open-channel thing? 36" wide 30" water depth flow is 2 feet per second ---------- Correct Answer ----------- 9.69 MGD

If equipment failure is the condition in which a piece of equipment does not operate as intended - --------- Correct Answer ----------- Failure Report

What is the highest Category? ---------- Correct Answer ----------- Category 4

  • / 4

Download Document

Buy This Document

$30.00 One-time purchase
Buy Now
  • Full access to this document
  • Download anytime
  • No expiration

Document Information

Category: Study Guides
Added: Aug 17, 2025
Description:

CWEA Electrical and Instrument Grade 2 Exam New 2024-2025 Version Best Studying Material with All Questions and Answers Temporary traffic control lanes created as part of a Temporary Traffic Contro...

Get this document $30.00