- | Page
DHL Interview ATPL Questions with 100% CORRECT ANSWER s
Question 1: What is the VOR change over distance?
CORRECT ANSWER: 60NM
Question 2: What is the minimum distance between parallel
runways?
CORRECT ANSWER : 915m
Question 3: What are the key points of using Mode 2 for parallel
runways?
CORRECT ANSWER : Only straight in approaches allowed,
interception angle of no more than 30 degrees, must be straight and level 1NM for localiser, must be straight and level 2NM for Glideslope, Minimum separation of 3NM on same Loc, Min separation of 2 NM on adjacent Loc, Missed approach tracks diverge by at least 30 degrees
- | Page
Question 4: What is the minimum time a flight plan must be
filed before departure?
CORRECT ANSWER : 60 minutes
Question 5: How does a pilot create a slip or a skid and how is it
indicated on the turn co-ordinator?
CORRECT ANSWER : Slip - opposite rudder to direction of
turn = ball will be at the same side of the turn, Skid - too much rudder in the direction of the turn = ball will be on the opposite side to the turn
Question 6: What time must ATC clocks be within?
CORRECT ANSWER : 30 seconds
Question 7: What are the Airspace separations rules for Class
A?
CORRECT ANSWER : IFR Only
- | Page
Question 8: What are the Airspace separation rules for Class B?
CORRECT ANSWER : IFR and VFR separated
Question 9: What are the Airspace separation rules for Class C?
CORRECT ANSWER : IFR separated from IFR, IFR Separated
from VFR, VFR Info about VFR, Speed limited below FL100 250kts, IFR (speed limit only on ATC instruction)
Question 10: What are the Airspace separation rules for Class
D?
CORRECT ANSWER : IFR Separated from VFR, IFR Info
about VFR, VFR Info about VFR, Speed limit below FL100 250kts
Question 11: What is the difference between Class D and Class
E airspace for VFR?
- | Page
CORRECT ANSWER : No ATC required, No SVFR
Question 12: What is Load Shedding?
CORRECT ANSWER : Reducing electrical load on the system
by turning off unnecessary electrical components
Question 13: How would an artificial feel unit be connected?
CORRECT ANSWER: In Parallel, otherwise if it failed it would
stop the system
Question 14: What are booster pumps?
CORRECT ANSWER : Low pressure centrifugal boots that
supply fuel to the engines.
Question 15: Why are booster pumps important?
CORRECT ANSWER : They prevent cavitation of the engine
driven pumps at high altitude.