C.A State Elevator Mechanic Study Guide Exam Questions and Answers Ladder must be installed if pit is deeper than... - Correct Answers ✅35" (3') ASME A 17.1 - 2004 2.2.4.2 Ladder shall not extend more than ___ above the sill. - Correct Answers ✅48" (4') ASME A 17.1 - 2004 2.2.4.2 Rungs (cleats or steps) of ladder should be a minimum of ___ wide. - Correct Answers ✅16" ASME A 17.1 - 2004 2.2.4.2 Siderails shall have a clear distance of not less than ___ from their centerline to the nearest permanent object. - Correct Answers ✅4.5" ASME A 17.1 - 2004 2.2.4.2 Ladder access shall not be permitted if pit is deeper than ___ below the sill of the access door. - Correct Answers ✅120"
(10') ASME A 17.1 - 2004 2.2.4.2
Illumination of pit and platform should be___. - Correct Answers ✅10FC ASME A 17.1 - 2004 2.2.5.1 Where should the light switch be located in the pit? - Correct Answers ✅Where accessible from the pit access door. ASME
A 17.1 - 2004 2.2.6.1
When the car is on compressed buffer, what is the clearance between the car and the pit? - Correct Answers ✅24" (2') 1 / 2
C.A State Elevator Mechanic Study Guide Exam Questions and Answers clearance. No part of the car should be touching the pit with a 24" (2') clearance. ASME A 17.1 - 2004 2.4.1.1 Where vertical clearances are less than ____", that area should be clearly marked on the pit floor. - Correct Answers ✅24" (2') Markings should be___" diagonal red and white stripes "Danger low clearance." - Correct Answers ✅4" When oil buffers are used, bottom runny should be no less than ___". - Correct Answers ✅6" When spring or solid buffers are used, bottom runny should be no less than ___". - Correct Answers ✅6" What is the maximum bottom runby on a car? - Correct Answers ✅24" (2') Buffer data plate letters shall be no less than ___" in height. - Correct Answers ✅1" What is the maximum bottom runby on a counterweight? - Correct Answers ✅35" (3')
- / 2