C-39 Roofing Trade Exam Version 3 Newest

Study Guides Aug 23, 2025
Loading...

Loading document viewer...

Page 0 of 0

Document Text

  • | P a g e

C-39 Roofing Trade Exam Version 3 Newest 2025/2026 Complete 100 Questions And Correct Detailed Answers (Verified Answers) |Already Graded A+||Brand New Version!!

When installing composite shingles on a roof with a slope of less than 3:12, a common practice is to: - ANSWER-Use double layers of 15 pound felt for an underlayment

You must notify DOSH if asbestos concentrations reach: -

ANSWER-0.1%

One of the disadvantage of using Hypalon is that it breaks down

when exposed to: - ANSWER-None of the above, Hypalon is

resistant to all of these

Sections of metal roofing are usually referred to as: - ANSWER-

Pans

The best roofing method for metal roofs that have only a slight

slope is to use a: - ANSWER-Flat seam

  • / 3
  • | P a g e

When installing a flat seam roof, the seams may be sealed with a sealant except where the slope is less than _______, in which

case the seam must be soldered. - ANSWER-3:12

Flat seam roofs of slight pitch should be divided by expansion

battens into sections not exceeding: - ANSWER-30 ft square

Before installing a flat seam roof, a wood deck should be

covered with: - ANSWER-30 lb felt

In the flat seam roofing method, the roof is covered by plans

made from: - ANSWER-20" x 28" sheets

What is the minimum gage copper recommended for flat seam roofs? - ANSWER-16 oz

Batten seam roof are not recommended for roofs having a slope less than: - ANSWER-3:12

Which of the following metals will expand the most? - ANSWER-Aluminum

  • / 3
  • | P a g e

Which of the following metals will expand the most? - ANSWER-Zinc

0.020" thick aluminum is approximately: - ANSWER-24 gage

0.020" thick copper approximately equals: - ANSWER-24 gage,

B&S

Which is lowest on the galvanic scale? - ANSWER-Steel

Which has the least rigidity? - ANSWER-16 oz soft copper

When joining 22 oz copper sheets, which procedure would produce the strongest joint? - ANSWER-Sheets lapped, riveted, and soldered

A 10' length of stainless steel will expand _______ with a temperature increase of 100*F - ANSWER-1/8"

Sheet copper is over _______ wide. - ANSWER-24"

  • / 3

Download Document

Buy This Document

$30.00 One-time purchase
Buy Now
  • Full access to this document
  • Download anytime
  • No expiration

Document Information

Category: Study Guides
Added: Aug 23, 2025
Description:

C-39 Roofing Trade Exam Version 3 Newest Complete 100 Questions And Correct Detailed Answers (Verified Answers) |Already Graded A+||Brand New Version!! When installing composite shingles on a roof ...

Get this document $30.00