ASE G1 Test Questions Answers 55

ASE G1 Test Questions & Answers | 55 Questions with 100% Correct Answers | Verified | Updated

Question 1: Coolant should be tested for

• Proper color
• Freezing point (temperature)
• Specific gravity
• Both b and c

CORRECT ANSWER : d. Both b and c

Question 2: Two technicians are discussing a compression

test. Technician A says that the engine should be cranked over with the pressure gauge installed for "4 puffs." Technician B says that the maximum difference between the highest- reading cylinder and the lowest-reading cylinder should be 20%. Which technician is correct?

• Technician A only
• Technician B only
• Both Technicians A and B

• Neither Technician A nor B

CORRECT ANSWER : c. Both Technicians A and B

Question 3: Technician A says that oil should be squirted into

all of the cylinders before taking a compression test.Technician B says that if the compression greatly increases when some oil is squirted into the cylinders, it indicates defective or worn piston rings. Which technician is correct?

• Technician A only
• Technician B only
• Both Technicians A and B
• Neither Technician A nor B

CORRECT ANSWER : b. Technician B only

Question 4: During a cylinder leakage (leak-down) test, air is

noticed coming out of the oil fill opening. Technician A says that the oil filter may be clogged. Technician B says that the

piston rings may be worn or defective. Which technician is correct?

• Technician A only
• Technician B only
• Both Technicians A and B
• Neither Technician A nor B

CORRECT ANSWER : b. Technician B only

Question 5: Leaking antifreeze can be what color?

• Green
• Orange
• Red
• Any of the above

CORRECT ANSWER : d. Any of the above

Question 6: What precautions are needed to be performed to

help prevent air from getting trapped in the cooling system when replacing coolant?

• Use the proper antifreeze as specified
• Open bleeder valve(s) during filling
• Use premixed coolant
• Wear protective gloves

CORRECT ANSWER : b. Open bleeder valve(s) during

filling

Question 7: When replacing a water pump, be sure to

• Torque all fasteners to factory specifications
• Use a new gasket/ seal
• Check that the accessory drive belt is properly aligned and

adjusted to the proper tension

• All of the above

CORRECT ANSWER : d. All of the above