ASE G1 Test Questions Answers 55

ASE G1 Test Questions & Answers | 55 Questions with 100% Correct Answers | Verified | Updated

Question :All of the following can cause a problem in the

Hydro-boost system EXCEPT:

• loose power steering pump belt
• leaking power steering hoses
• low power steering pump pressure
• leaking check valve

Correct answer:D

Question :A vehicle equipped with a MacPherson strut

suspension is in the repair shop for new tires and an alignment. The technician noticed that the vehicle has some play in the lift-side inner tie-rod. What should the technician tell the customer?

• It is not a problem that will affect alignment.
• He can align the front end, but the tie-rod should be

replaced soon

• The inner tie-rod needs to be replaced before an alignment

can be performed

• He can set the vehicle alignment to compensate for the

play in the inner tie-rod

Correct answer:C.

Question :All of the following should be performed during a

preliminary transmission inspection EXCEPT:

• check transmission fluid level
• visually check wiring and electrical connections
• check the condition of the filter
• check for fluid leaks

Correct answer:C

Question :A smeary film on the windshield is an indication

of:

• evaporator core leak
• water valve leak
• heater core leak

• restricted drain hose

Correct answer:C

Question :A rear wheel drive vehicle with a one-piece

driveshaft has excessive driveshaft vibration during low speed acceleration. Which of the following is the MOST likely cause?

• binding U-joints
• excessive driveshaft runout
• driveshaft out of balance
• improper driveshaft angle

Correct answer:D

Question :When replacing an integral hub/bearing assembly

on a front wheel drive vehicle, all of the following must be

removed EXCEPT:

• brake rotor
• brake caliper
• steering knuckle
• wheel

Correct answer:C

Question :The warning light on a vehicle with an anti-lock

brake system lights when the vehicle is started. When the vehicle is moving, the light stays on. Which of the following could be the cause?

• mis-adjusted wheel sensor
• bad air release solenoid
• blown fail-safe monitor fuse
• bad warning light relay

Correct answer:A.

Question :All of the following are procedures for removing

air from a hydraulic system EXCEPT:

• bench bleeding
• power bleeding
• manual bleeding
• vacuum bleeding

Correct answer:A