ASE A4 Practice Test 2024 Edition Questions and Answers Steering Systems Diagnosis and Repair
- Technician A says if the steering column input shaft is not aligned correctly there would be noise. Technician B
says if the lubricant level is low in a linkage-assist type power steering column, there will be a noise when turning the steering wheel. Who is right?
- A only
- B only
- Both A and B
- Neither A nor B
- A sport utility vehicle has high steering effort. Technician A says this could be caused by a sheared shift tube.
Technician B says the steering column assembly is misaligned. Who is right?
- A only
- B only
- Both A and B
- Neither A nor B
- Technician A says whenever working on the steering column, consult the on-line service information for the
recommended airbag disabling procedure. Technician B says the u-joint or flexible coupling must be removed before the steering wheel can be removed. Who is right?
- A only
- B only
- Both A and B
- Neither A nor B
- This question has the word LEAST. For this question, look
for the choice that would LEAST LIKELY cause the described situation. Read the entire question carefully before choosing your answer. While driving a vehicle at 40 miles per hour there is a vibration in the steering wheel.Which of the following is the LEAST likely cause?
- Improper wheel balance
- Worn control arm
bushings
- Bent wheel
- Shifted belt inside tire
Study Online
- On an integral power steering gear, which of the following
indicates excessive play between the rack piston and sector?
- Lost motion within steering gear
- Steering wheel vibration
- Hard steering condition when cold
- Hard steering condition when hot
- / 1