2024 MKC SWE Study Questions with Complete Solutions P100 dipstick location - Correct Answers ✅2 dipsticks on each side of the engine P100 engine specification - Correct Answers ✅Yanmar L100AE/EE air cooled, single cylinder, 4 stroke, diesel F-76 or JP-5 P100 Specifications - Correct Answers ✅164lbs of wet weight, 1.45 Gallons of fuel 2.75 hrs of run time 100GPM@83PSI@20ft lift, packing screw 6" long 9/16 wrench, drip rate 5-50 DPM Securing P100 - Correct Answers ✅turn speed to low, run with no load for aprox 5 minutes to allow it to cool off P6 Specs - Correct Answers ✅Honda GX200, 6.5HP, 3Gal tank, 4hour run time, 86 octane gas,unit 60lbs, kit 120lbs P6 Dry run time - Correct Answers ✅This pump is equipped with a mechanical lip seal. Avoid running the pump dry or at high speed if there is no discharge water. If there is no discharge flow after two minutes, shut down the engine and check for leaks in the suction hose P6 Maintenance - Correct Answers ✅• Automotive 4 stroke SAE 10W-30 detergent oil is recommended for the engine for general operation. See the Honda GX200 Engine Owner's 1 / 2
2024 MKC SWE Study Questions with Complete Solutions Manual for oil recommendations for adverse operating conditions. • Check the engine oil level prior to each use. Add oil as necessary. • Change the engine oil after the first 20 hours; then every 100 hours, or 6 months thereafter. • Replace the inline fuel filter after the first 20 hours; then every 100 hours, or 6 months thereafter.P6 time between fuel tank changes - Correct Answers ✅30 seconds P6 securing - Correct Answers ✅1. Return the throttle to the "IDLE" position. 2. Close the fuel valve by pushing it to the left to the "OFF" position. 3. Shut down the engine by turning the ignition switch counter clockwise to the "OFF" position P6 Fittings - Correct Answers ✅15' 3" dia camlock rigid suction hose with strainer, 20' 3" dia camlock fiber reinforced flexible hose 250GPM@12' lift @3900RPM, Set the throttle about 1/3 open., P6 speeds - Correct Answers ✅Idle 1400 full throttle 3900 Pressure gauge and transducer calibration interval - Correct Answers ✅24 months Meter calibration interval - Correct Answers ✅24 months
- / 2